Air Exchange Type Aging Oven (KOVU-216L)

Interior hot air circulation pushes the specimens aging in a guaranteed airing and good uniformity environment. Equipped with ventilation fan and over temperature relay.
Can also be used as Drying Oven by changing the test frame rack.

Air exchange type aging oven is used for testing insulator of wires or rubber specimens to compare the change of tensile strength and elongation rate after aging test.
Air exchange rate test method and calculation
Block all of ventilation holes, door(s), temperature probe hole, especially the hole for shaft of air circulation fan before test, otherwise will cause remarkable test error.
Connect the Watt Mater to power of the Oven (according to ASTM standard, resolution of the Watt Meter should be 1.0Whr.and 1hour.).
Rise up the temperature inside the oven to 80±2℃ above room temperature. Measuring position of room temperature should bar at 2m from the oven and at almost the same height of the air inlet, should also be away at 1m from any other object.
Measure the power consumption (W) for half an hour, times 2 to get the value of 1 hour.
Remove all the seal materials and measure the power consumption under air exchange by using the same way.
Hence use the following formula to calculate the Air Exchange times per hour. N=3590(X-Y)/V*D*∆T
N: number of air exchange per hour
X:average power consumption in watts hour during ventilation by the watt-hour reading V:volume of the testing chamber cm3
Y:average power consumption W-hr with no ventilation obtained by the same way.
D:density of the ambient room air during the test g/cm3
∆T:difference of temperature between the testing chamber and the ambient room air 0℃